| Subject | Text |
| I hate Pioneer. But, they will sell you complete replacement boards. Figure out which brd it is. The |
| If you had no blue yes. Check all three transistors on the crt brd and make sure there all about the |
|
|
| I’d replace the ssb. Small signal brd. Listen to Brian and take down the values. If you need the par |
| 2SC3788 on the crt brd if you had no red but, Just go into the service menu and adjust red bias. |
| Repalce the caps on the pip board or pull the pip brd out and jumper pins 5 to 11 and 7 to 9. |
| Check the fuse's on the sustain brd. Unplug the connector if the Vsc doesn't come back up yes a bad |
| Get the oe remote and if you take the back off look for the # of the convergence brd. There's a link |
| [quote:e5d68b35f4="minnie"]2SC3788 on the crt brd if you had no red but, Just go into the service me |
| CHECK C914 22 UFD 50 V AND C915 220 UFD 50 V ON THE POWER/SOUND BRD. CHECK FOR SHORTED OR LEAKY D50 |
| Check R608 and see if it's open. C brd is the crt brd. |
| One should be soldered into the crt brd and the other should go into the crt socket. Which one are y |
| [quote:370c433a35="minnie"]2SC3788 on the crt brd if you had no red but, Just go into the service me |
| Toshiba CZ32V61 TV remote sensor not working at times. | Toshiba TV Remote Sensor is not receiving a signal from the Remote Control at times. I have purchase |
| [quote:961f515806="Frank"][quote:961f515806="minnie"]2SC3788 on the crt brd if you had no red but, J |